Denso BHT-200QW Dokumentacja Pobierz pdf (Strona 20)

Settable Parameters

▪ POWER

The wireless module power mode can be set. The following 6 power modes are available. The default is

P_PWRSAVE_MOST.

Power Mode Power Consumption Status

FULL Consumes much power (no power saving effect)

MOST

MID

LESS

LEAST

Consumes much power (little power saving effect)

The BHT may take a little more time to establish a wireless connection or

issue responses with little power consumption (large power saving

effect).

[Ex.] Set the power mode to "Cosumes much power"

RF.Settings.PowerSave = RF.Settings.EN_POWERSAVE.FULL

- 18 -

▪ ESSID

Specify a character string for the ID used on the wireless network. The ESSID for the BHT should be the

same as the SSID for the communication access point. If the ESSID is set incorrectly, no communication

will be possible.

[Ex.] Set the "BHT200" to the ESSID

RF.Settings.SSID1 = “BHT200”

▪ AUTHENTICATION

Authentication method setting: Open or Shared can be selected.

Select Open when the WEP setting is OFF.

Select Shared when the WEP setting is ON.

[Ex.] Enabling (128-bit) the WEP settings.

RF.Settings.Authentication = RF.Settings.EN_AUTHENTICATION.SHARED128

▪ WEP KEY

Four types of encryption key (WEP KEY) from 1 to 4 can be set.

When the WEP setting is ON, select a WEP KEY from 1 to 4 using the Transmit Key.

[Ex.] Setting WEP key 1 to ”01234567890123456789ABCDEF” (128-bit).

RF.WepKey(1) = ”01234567890123456789ABCDEF”

▪ TRANSMIT KEY

Select the WEP KEY actually used from the set WEP KEY 1 to 4.

[Ex.] Using WEP key 1.

RF.WepKeyCollection.TransmitKey = 1

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 376 377

Brak uwag

Denso BHT-200QW Dokumentacja Strona 20